Using Create and Modify in Primer

I wanted to change the stitch design of an embroidery I made in Create.  The design looked nice, but I wanted to change the stitch type to one I really liked.  At first I tried making all my changes in Modify thinking that this would make things easier however it didn't so I played a little and below are my results...

All changes were done in Modify
Changed stitch design from 3 to 36.
Trimmed and Stitchs Optimized

Design change of stitch design from 3 to 36 only (no trim or stitch optimization),
was done in Modify.

Stitch design was changed from 3 to 36 in Create.
Then copied and pasted to Modify for removing trim
commands and optimizing stitches.


The finished product!

Ok, ok, the "k" has a glaring problem.  Although I can assure you it does not when doing embroidery on normal fabric (check my Etsy listing to see the embroidered tea towel).  I am also not sure if the problem is partly due to using two threads to create a variegatedlook  as much as it is the design on burlap (loose, not doubled).  I had such a hard time choosing a color from my stash to use that I combined the two I was most considering.